MADRIX Forum

Hi lughscape,

Do you have a datasheet of the protocol? If yes, please send it to info[at]madrix[dot]com so we can check if there is any alternative protocol and if we can implement it for the MADRIX NEBULA.

Thanks in advance!

Hello edyzee11,

Welcome to the MADRIX forum!

Please send us your MADRIX 5 setup file and a logfile via e-mail to info[at]madrix[dot]com.
To save the logfile please start MADRIX and select "Tools" > "Logfile...", click the button "Save As..." and enter a name for the logfile.

Thanks in advance!

Hi Mathieugoinsamy,

This will be difficult with one instance of MADRIX 5.
You could use designated layers for each of the rooms, but you are right: If you change the Storage Place, all the rooms/areas will change.
Now it depends a little bit on the effects if the transition is visible (e.g. you ...

Hi Eric,

MADRIX builds a bounding box around the fixtures, when creating a fixture group:
- MADRIX uses the bounding box of the fixture group with only its largest dimensions in X, Y, and Z. All effects inside the bounding box will be included for the rendering calculation.
- In your case a ...

Hi lughscape,

Thank you for your report!

It seems to be a firmware issue, which appears if you use the same subnet as in the USB-C settings. I'm sorry! Please use a different subnet e.g. 192.168.12.xxx/24

Hi ckleinerman,

This is hard to say. I'm optimistic that it is going to be released within one month.

Hi n3h,

Please further elaborate on your request. What do you try to achieve?

Hi RockitFX,

Please send us your MADRIX 5 setup and a logfile to info[at]madrix[dot]com. To save the logfile please start MADRIX and select "Tools" > "Logfile...", click the button "Save As..." and enter a name for the logfile.

Thanks in advance!

Hi ckleinerman,

The HD108 protcol is not supported, yet.
It will become available with the next firmware release.

Hi Dohyun Kim,

Thank you for the screenshots.

Please send us your MADRIX 5 setup and a logfile to info[at]madrix[dot]com. To save the logfile please start MADRIX and select "Tools" > "Logfile...", click the button "Save As..." and enter a name for the logfile.

Thanks in advance!