MADRIX Forum

Hello evs.ruda,
Welcome to the MADRIX forum.

If you want to control a MADRIX AURA remotely or record data from MADRIX software to the AURA, both devices to work in the same IP address range. It is not possible to have both devices working in different networks.
If the MADRIX PC and the AURA are too ...

Hello UpLighting,

To change the layer opacity for an effect layer in the Timeline you have to select the desired layer at the "Layer Opacity" section in the Timeline. Once the desired layer was selected you can add the desired layer opacity values at the desired timing.

Under the following link ...

Hello steuned_,

At the moment MADRIX is working with a native 8 Bit dimming of every color values.
It is not possible to control parameters of fixtures with real 16 Bit.

In your explained scenareo you can:

- Work with a 16 Bit mode at the fixtures and emulate it with MADRIX like explained in a ...

Hello michielan,
Welcome to the MADRIX forum.

The MADRIX effects are working according to the patch underneath. That
means you will need to patch/place the desired fixtures at the correct
position. That means for instance the fixtures on the top left side in
real should be located also on the top ...

Hello steuned_,
Welcome to the MADRIX forum.

MADRIX is corrently working in 8bit mode with the colors. Of course you can emulate the coarse and fine channels if you will assign both channels the same color. In that case the value of both channels will be increased/decreased at the same time to get ...

Hello Mattlightd,
Welcome to the MADRIX forum.

At the moment a Cue List is not pausing after a Cue with duration was played. It calls the next Cue and will stop. If you now call the "Go" command again, it will start from the beginning (because the Cue List was stopped).

At the moment you can ...

Hello Fritz_HXAV,
Welcome to the MADRIX forum.

The chosen approach is a valid and common method even if not the recommended one.

An alternative approach would be to add one or more Effect Layers to each Storage Place that are responsible for controlling the Spot Lights. This means the workflow ...

Issue:
RDM devices connected to third-party RDM Art-Net nodes are not discovered by RADAR.

Possible reasons for the issues:
The connected Art-Net node does not automatically generate the TOD (Table of Devices) data.

Possible Solution:
In RADAR, activate “Force RDM discovery by sending ...

Hello ChrisCotton,

In the attached image you can see an example how a 3D video/moving image content needs to be prepared and loaded in MADRIX. In this example every Z-Layer was added side by side and thus a large 2D image/video was created. It is important that a slice has the correct size. That ...

Hello UpLighting,

The AURA has no audio analysis included. That means you can only playback a recorded specturm analization from MADRIX. If you want to output this recorded scene it will look always like the recorded one.